DIY Remote Control Holder

 IMG_0885
DIY Remote Control Holder
I don’t know about you but I’ve noticed that I always lose the remote.  Well I’ve always lost the remote.  It progressively got worse after kids.  Why do kids think that remotes are toy phones?  Ok…off track but yah. I was having trouble finding a basic holder to make, so I decided to just figure out!

Need…

  • Front fabric either 1/2 yard or 2/3 yard depending on the direction of the print
  • Back fabric either 1/2 yard or 2/3 yard depending on the direction of the print.
  • Pocket fabric either 1/4 yard or 1/2 yard depending on the direction of the print
  • 12″ dowel
IMG_0870
Cut…
– 13″ x 22″ front fabric
– 13″ x 22″ back fabric
– 13″ x 9″ pocket fabric
Sew 1/2″ of the top of the pocket down.
Place the pocket down on the front fabric.
 IMG_0873
Pin in place with pinning the stitch line to separate the pocket.
Sew the line.
 IMG_0874
Pin the back fabric onto the front/pocket fabric pieces.  Be sure that they are place print side in.
Sew 1/2″ along the two long edges and the short edge without the pocket.
Turn right side out.
Place in 12″ rod.
 IMG_0871
Sew rod in place.
Close the bottom.
 IMG_0875

Leave a Reply